Problem- Canned cycle

[tsaladyga]

Hi all,
I need some help on my post.
I am programming an Ingersoll Gantry mill. The canned cycles spit out the "G" code on every line. EX:
G81 X-5 Y5 Z-18. R4. Q.1 F1.1 (It is a weird s/up I know. Z= top of stock, Q= reference height, R=depth)
G81 X-12.
G81 Y-5
Etc......
So my question is how do I spit out the first line as shown, and how do I get the post to spit out the "G" code on every line?
I am using McamX & mpfan for my post.
Any help would be greatly appreciated

[ObrienDave]

Lets see...

The canned cycles spit out the "G" code on every line. EX: G81 X-5 Y5 Z-18. R4. Q.1 F1.1 (It is a weird s/up I know. Z= top of stock, Q= reference height, R=depth) G81 X-12. G81 Y-5 Etc...... So my question is how do I spit out the first line as shown, and how do I get the post to spit out the "G" code on every line?

It seems the NC code is exactly what you're asking for.
What is it you need help with?