| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-12-2009, 07:13 AM
| ||||
| ||||
Hey peoples, I am in need of a mill post for an Ingersoll Gantry mill w/ Allen Bradley 8200 control. It has a "z" axis and a "w" axis for the gantry. Not sure how to configure my post to recognize this. If anyone can help I would be in your debt. I am using MCX2, but a v9 0r v8 post will do fine. Thanks Last edited by tsaladyga; 08-12-2009 at 07:40 AM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Allen Bradley Series 8200 Controller | ImanCarrot | Controller & Computer Solutions | 5 | 02-04-2010 04:35 AM |
| Allen Bradley Ultra 100 drive with non Allen motor? | DennisCNC | Servo Motors and Drives | 7 | 10-29-2009 07:44 PM |
| Need Help!- Mastercam post for allen bradley | tsaladyga | Post Processor Files | 6 | 08-18-2009 11:12 AM |
| Allen Bradley 8200 control | gnmachine | General CNC (Mill and Lathe) Control Software (NC) | 4 | 04-05-2007 07:19 PM |
| Allen Bradley plc 500 | phil spanner | Computers and Networking | 6 | 01-31-2007 11:16 PM |
| | |
need post for allen bradley 8200 
Linear Mode
