edit MC9 post

[mcgn21]

Quick question for you guys. I am using MC9 and when I post to the machine the post generates a G54 on every line that has a X or Y movement unless it is in a canned cycle. An Example:
G54 G1 X2.5
G54 G3 x2.0 y 2.75 I X.XX
G54 G1 Y 3.0
The machine runs the post just fine but it is annoying. I've edited the post for other things just fine but I do not know what I'm looking for to get rid of this. The post is the mpfan.pst. Your help would be greatly appreciated.
Mike.

[Superman]

GOLDEN RULE #1 -back_it_up before altering

Do a file compare on your post and the original post, it will high-light any differences. Or copy the backup copy onto your post if there are only minor differences.

G54 being output is not common, so the post could have been edited accidently of otherwise, This code is controlled by "Misc Interger" #1 , to output for other reasons, the post has been diddled, file compare should show it up.