Problem- I&J arc output instead of R

[zelaznog]

I'm having problems, I want I & J values instead of R value.
I can't find the "arcoutput$" value in my postprocessor file.
I am adapting one Mcam V9.1 to McamX.
Anybody help!!!
thanks

[weirdharold]

I set this up in my Control Definition, / Control topic's, / Arc. I know some post's have this switch, but you say your post does not have this feature. This is my set up with Mpmaster Control Def. in X3. hth.
Harold C.

[zelaznog]

Harol,
I did the changes that you suggested without good results.
Do you have something else in mind to help me out?
Regards

[beege]

Did you try to look for "arctype" in your post? Type in type 2, not type 5 or 6

[zelaznog]

Beege,
I did change the arctype without good results.
please see attached doc file.

thanks

[minardsanders]

I don't know alot of anything about these post processers, but aren't I&J departure command's from where you start in a arc, and X&Y where your going to, forgive me if I"m out of line. Minard

[cyrus2000]

Originally Posted by zelaznog I'm having problems, I want I & J values instead of R value. I can't find the "arcoutput$" value in my postprocessor file. I am adapting one Mcam V9.1 to McamX. Anybody help!!! thanks

Go to-Settings--Machine Definition Manager--Edit the control definition--Arc--Arc center type --Delta start to center.
enjoy