Need MCAM9 lathe post for Fanuc OT Control

[Rylee]

Hey anybody! I am running Mastercam 9 and need a lathe post for a Daewoo Puma 6-HS with a Fanuc OT control. I am new to the site and posted this same question in another forum I apologize for that, but any help would be greatly appreciated.

Thanks

[tobyaxis]

Hey anybody! I am running Mastercam 9 and need a lathe post for a Daewoo Puma 6-HS with a Fanuc OT control. I am new to the site and posted this same question in another forum I apologize for that, but any help would be greatly appreciated.

Thanks

I doubt anyone is going to give you a post, but they might be willing to help you edit a post for your needs.