Need Help! Need MCAM9 lathe post for Fanuc OT Control - CNCzone.com-The Largest Machinist Community on the net!

Rylee · #1 03-12-2009, 11:39 AM

Hey anybody! I am running Mastercam 9 and need a lathe post for a Daewoo Puma 6-HS with a Fanuc OT control. I am new to the site and posted this same question in another forum I apologize for that, but any help would be greatly appreciated.

Thanks

tobyaxis · #2 03-12-2009, 12:20 PM

Originally Posted by Rylee

Hey anybody! I am running Mastercam 9 and need a lathe post for a Daewoo Puma 6-HS with a Fanuc OT control. I am new to the site and posted this same question in another forum I apologize for that, but any help would be greatly appreciated.

Thanks

I doubt anyone is going to give you a post, but they might be willing to help you edit a post for your needs.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ikegai fanuc fx lathe 5t control	caddyshack	5T/5M	20	11-19-2011 06:39 PM
Fanuc Oi-Tb control post for lathe for Gibbs	metalman21	GibbsCAM	4	12-10-2010 12:31 PM
Fanuc Oi-TC control on a Dalian lathe	jeep534	Fanuc	2	12-08-2008 04:29 AM
Mcam9 Lathe setup for new machine	whelzorn	Mastercam	4	01-19-2007 08:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)