| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-21-2009, 05:37 PM
| |||
| |||
Hey All, MC9.1-I've been working on writing a post for a Star SR-20(Swiss-type lathe) It's an altered form of MPLFAN post One thing I can't seem to figure out how to do: When using the C-axis cross contour or cross drilling toolpaths, I need the nc file to post with the x and y axis' swapped Ex. Drill going into the side of the part, traveling towards the center, would be a "y" move. If anyone could point me in the right direction, would be very much appreciated Thanks Ace  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Milling with bottom vs milling with side? | REVCAM_Bob | CNCzone Club House | 13 | 06-30-2008 09:23 AM |
| Z-axis - mounting rails on spindle side, rather than tower side | guru_florida | Linear and Rotary Motion | 7 | 01-31-2008 06:54 PM |
| Side Milling | SKEETO | General Metalwork Discussion | 3 | 12-17-2007 06:04 PM |
| Milling flats on the side of round stock | MichaelHenry | SprutCAM | 18 | 10-21-2007 06:36 PM |
| Help required PCB drilling and milling cnc | sujeet_nayak | Milltronics | 4 | 04-11-2007 04:49 PM |
| | |
Linear Mode
