Mastercam 8 post help for Dynapath 10

[greggv]

Hi! I'm using Mastercam's mpdypth post, and most of it is fine. Two problems: First tool call is output like this (M03T01S2400$) I need a seperate M06 for the tool, I need the tool designated as T0101 (tool number and tool offset) and I need a seperate M03. How do I do this? The next tool calls are OK, except for the tool number as stated above. Thanks! Gregg

[masspfei]

Look at the section that is posting correctly, and modify the first the same way. I know that is a generic answer, but its better than contact your reseller BTW, if you attach your post I will look at it for you, but the best way to learn is to do it....

Steven

[tlhbear55]

i have the Mastercam post if you need it reply

[tlhbear55]

i have 2 mpDyna24 & mpdypth

[phoodieman]

I have a post for the Dyna Path Deltal controller. (The old Autocon). I have a post that posts out nearly everything I need. I have been able to modify the post to get everything except the tool designation that you are talking about T0101 I'ts somewhere in the fms area, but I can't get it to work.

Phoodieman

[machinist360]

If anyone is still active that has this post I would like to borrow it.

[Mike Mattera]

FYI: The MPDyna24 is not a Dynapath post.

"If anyone is still active that has this post I would like to borrow it."
Borrow it...
Are you going to give it back when your done?

I have several posts for Dynapath. You can contact me if you like.

Mike Mattera

[phoodieman]

Hi! I'm using Mastercam's mpdypth post, and most of it is fine. Two problems: First tool call is output like this (M03T01S2400$) I need a seperate M06 for the tool, I need the tool designated as T0101 (tool number and tool offset) and I need a seperate M03. How do I do this? The next tool calls are OK, except for the tool number as stated above. Thanks! Gregg

I had my post edited for everything I needed except the tool designation. I needed T0101 (for tool one), but only could get T0001 posted out. This isn't a post solution, but it works and I don't have to make ANY edits. Straight to the machine then cycle start. For tool one for instance, I name the tool "101" for two "202" ect. in Masterecam. Tool 11 would be "1111". I just got tired of having to edit especially when I was running a lot of tools. Not a perfect solution but one I can live with.

phoodieman