Need Help! Servo II Post - CNCzone.com-The Largest Machinist Community on the net!

MikeA · #1 09-15-2008, 09:54 AM

Well I went and done it now. I have lost my working version of Servo II post through a hard drive failure. This machine operates on dos based computers only (windows 98) and the old computer I had gave up the ghost. The post I have off the MC V9.1 disk is not quite right particularly the way it handles tool changes and keeps putting in unsupported G commands. I need a fresh start if someone has a post or the appropriate tweaks.

MikeA · #2 09-17-2008, 08:04 AM

No Servo II / Mastercam users?

Grey · #3 06-15-2011, 03:36 PM

If you are willing to share the DOS Servo II software, I can modify the post for you. Just send me the post and software and what the output should be like and I will modify the post to your needs.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Servo cnc mill to Mcam 9.1 post?	greggv	Post Processors for MC	12	03-31-2010 11:00 AM
Servo II Post Sample Needed	Baytekk Designs	General Metal Working Machines	0	01-08-2008 04:15 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)