| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
08-14-2008, 08:41 PM
| ||||
| ||||
| The editor should be on your hard. Look in your hard drive. C:\mcamx\common\editors\mastercam or cimco You can use either one. You can set mastercam to look at one of them.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MC X Editor | cijunet | Mastercam | 2 | 02-21-2008 10:28 AM |
| x2 wheres the editor? | adamant | Mastercam | 3 | 01-23-2007 09:53 PM |
| Edgecam Editor | inflateable | EdgeCam | 8 | 09-26-2006 02:57 AM |
| Text Editor | mustangsally | G-Code Programing | 4 | 06-11-2006 01:17 PM |
| Editor | Okuma | General CAM Discussion | 3 | 01-07-2004 07:30 AM |
| | |
Linear Mode
