| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-12-2008, 10:02 AM
| |||
| |||
I have a mori with a fanuc compatible control and a 6 station 5c indexer on a trunnion table. the collets are my A axis and the trunnion is my B axis. I need a post to spit out the A and B correctly. I attempted to use a generic fanuc 5x mill post and it was posting out 5 axis', not correctly but at least there was 5 but now I get a message about startbin found but no endbin. Any ideas about this? OK, here is an update. I figured out about the startbin error, the post requires accompanying file. There was a .psb file and a .control file on the disk and once I put the in proper folder the post would work. Last edited by WingNutz; 08-13-2008 at 07:35 AM.  |
|
#2
08-21-2008, 05:09 PM
| ||||
| ||||
| Wingnut what version of MC are you running again?
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I cannot post work offsets with Camworks I may need Post for Acromatic?? | acromastic | Post Processor Files | 0 | 06-21-2007 03:56 PM |
| Need post Delcam PowerMILL post for Hardinge VMC 600 II with Fanuc Series oi-MB | littlem | Post Processor Files | 0 | 10-26-2006 04:59 PM |
| | |
Linear Mode
