Need Help!- mastercam post

[dahab]

We have a lot of new milling machines. the problem is we have also 2 old machines but no post processor.
i need the post proccesor for the dialog 4 and 12 can some one help me!

Casper

[robert copeland]

what kind of machines do you need post for I have over 50 in my file dir.

[Mike Mattera]

Please include less information so we can guess what you want.

Mike

[dahab]

I need the post for the FP3NC Deckel (dialog 4) and the FP3-50 Deckel maho (dialog 12). i hope you can help me

Best regards

Casper

[robert copeland]

Casper I have the following posts mpdia11b.pst
mpdia11a.pst
mpdia11.pst
mpdeckh.pst
mpdeck.pst
if any of these look good send me an e mail at robert.g.copeland@ngc.com

[g-codeguy]

Originally Posted by Mike Mattera Please include less information so we can guess what you want. Mike

Nice one, Mike!!! Don't know about the OP, but I got a chuckle.

[concoo]

pls help me the post for Doosan 21i. thx

[g-codeguy]

Originally Posted by concoo pls help me the post for Doosan 21i. thx

Not many will just give you a post. Don't even think about asking for one on emastercam. It is frowned upon.

However, there are lots of people on that forum and on this one that will help you solve any problem(s) you are having with your post. BUT you have to give us enough information to be able to help. Maybe post the output from the post processor, and then the same section modified to how you would like to see the output.

Adding a bit of dialog explaining the desired changes wouldn't hurt either.

[fireman323]

I am having a time trying to get my mcam x3 to post g code correctly to My boss 8 controller. Anyone have a post set up for that combination. My mcam software is a student version and no support from mcam is given.

Thanks in advance.

[fireman323]

I fiddled around with it and found a combination that works.

Thanks