| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-21-2004, 09:28 PM
| |||
| |||
 post help Is there any good book or cd out there for post modification? In the old versions of MasterCam there was a seperate book on posts. I have just aquired an old Dyna 4400 mill and would like to get a post modified for this mill. Mastercam has a post for the 2000 series so I will modify this post . These old Dyna mills did not use standard G&M codes so this will be a challenge . I have never done anthing this extensive in posts so I am floundering. Any help or direction would be great. Thanks Jim Walthall    |
|
#2
08-22-2004, 12:15 AM
| ||||
| ||||
| Your dealer should be able to get you a CD for post editing.
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Emco Compact 5 PC...have ???? | Double G | Mini Lathe | 42 | 08-22-2010 07:26 PM |
| Upgrading control hardware - Emco | eDudlik | General CNC (Mill and Lathe) Control Software (NC) | 21 | 12-08-2009 01:52 AM |
| v2xt post | jrrhotrod | Post Processors for MC | 25 | 12-10-2008 06:20 PM |
| post processor help | jrrhotrod | Post Processor Files | 8 | 01-14-2005 04:45 PM |
| One more little bump in the ProtoTrak post | Shadowfaxx | Post Processors for MC | 1 | 01-04-2005 11:10 PM |
| | |
Linear Mode
