Looking for v9.1 Mastercam post for Mach Plasma

[harry320]

Hi All,
I'm a Hobbyist and have Mastercam Mill 9.1 that I use with a Bridgeport controlled by Mach3. I have built a plasma table and have been using the mill version to create my code with one problem. I have to go in and manual edit in M3-M5 for torch start and stop. Does anyone have a Mastercam post that they are using for plasma that they would share?
I have tried to edit my post to create the needed M codes but have been unsuccessful. The cost of a new post verses sheetcam for plasma are about the same, I just already have many hours invested in learning Mastercam and hate to start over with another cam program. Any help or suggestions would be appreciated.
THX Harry

[crazythunder]

I would recommend you using a Mi integer to do this. Very easily added. Look at the Free MPMASTER post on the emastercam web site and use it to help you road map the very easy fix in your existing post. I know about 12 dealers all of whom would do this for free surprised when you contacted your dealer they would not help.

I know the dealer in your area and they help people all the time you might try contacting them and they should be able to help you very quick.