editing okuma c-axis post

[kazmir44]

I'm trying to make some changes to my c-axis post for version 9.

This is what i am getting at the beginning of my program now.
O0000 (L222 )
N1
( TOOL - 1 OFFSET - 1 )
( CIRCMILL .375 CARB ENDMILL 1" L.O.C., TOOL OUT 1-1/4 )
( 1ST OP )
( PART # )
( REV. " " )
( DATE ORIGINALLY PROGRAMMED 00/00/00 )
( PROGRAMMED BY )
( STOCK IS )
( CHUCK ON STOCK DIA. " DEEP )
( WITH FULL CHUCK PRESSURE )
( UNDERCUT YOUR JAWS FOR A GOOD GRIP )
( *** )
G13
G0 X100. Z0. M05
M110
G136
T0101 SB=2000 M41 M13 M8
G0 X3.6 Z.1
C0.

and at the end

G0 Z.1
M9
M12 M02

I need it to be:

$L222.MIN
(L222.MIN)
( 1ST OP )
( PART # )
( REV. " " )
( DATE ORIGINALLY PROGRAMMED 00/00/00 )
( PROGRAMMED BY )
( STOCK IS )
( CHUCK ON STOCK DIA. " DEEP )
( WITH FULL CHUCK PRESSURE )
( UNDERCUT YOUR JAWS FOR A GOOD GRIP )
( *** )
N1
( CIRCMILL .375 CARB ENDMILL 1" L.O.C., TOOL OUT 1-1/4 )
G0 X50. Z50. M05
M110
G136
T0101 SB=2000 M41 M13
G0 X3.6 Z.1 M8
C0.

and

G0 Z.1
M12 M9
X50. Z50.
M109
T1100
(L2222.MIN)
M30

I also need it to post out c and x locations in my drill tap and thread cycles.
Can someone help me out.
Any help at all would be greatly appreciated.

Thanks,
Jake

[kazmir44]

got it to post out this at the end of the program.

M9
M12
M109
T1100
(L222.MIN)
M30
%

but i still need it to go to the home position before the tool change.

[crazythunder]

"$", sprogname,".MIN", "%", e #Tape File Name

That Should give you the header information.

The end someone has modified the standard post and messed up the X and Y position outputting get a generic post and replace what was taken out.