| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
01-21-2008, 01:50 PM
| ||||
| ||||
| I have programmed the anilam a few years ago using MasterCam. It will read standard G code. I think I used I and J with absolute values not delta values. Look for that setting in the post processor.
__________________ ObrienDave. MasterCam since V6. Gcode since 1983. Be careful, the nose you punch today may belong to the butt you have to kiss tomorrow.  |
|
#3
01-21-2008, 02:15 PM
| ||||
| ||||
| -
__________________ Stefan Vendin |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nano Interpolation vs 104/D | TDavid | Fadal | 7 | 03-30-2006 05:36 PM |
| involute interpolation | utengineer04 | G-Code Programing | 0 | 04-26-2005 12:17 PM |
| Helical Interpolation | dbcoop11 | Bridgeport and Hardinge Mills | 4 | 12-31-2004 10:15 AM |
| interpolation | rimcanyon | General Electronics Discussion | 9 | 04-08-2004 01:10 AM |
| | |
Linear Mode
