| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-21-2007, 11:12 AM
| |||
| |||
I'm using the Generic Fanuc 3X post with a Hurco VM1. I like to set my tool offsets in the controls tool setup, and would like to change the post to not put a G43 H in my .NC But I'm not sure how to do it any thoughts? Last edited by Gstuck; 10-21-2007 at 01:46 PM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Disabling Help Wizard | wildcat | Mach Software (ArtSoft software) | 0 | 02-19-2007 10:40 PM |
| Need post Delcam PowerMILL post for Hardinge VMC 600 II with Fanuc Series oi-MB | littlem | Post Processor Files | 0 | 10-26-2006 04:59 PM |
| Disabling drive when not in use | rkonnen | Servo Drives | 9 | 09-12-2006 05:48 AM |
| | |
Linear Mode
