how do I....

[gearsoup]

I want to tweak my post a little to give me the following code when the Z goes home for a toolchange:

G0Z.25M9
G91G30Z0.M19
M1

Right now, it's giving me:

G0Z.25
M5
G91G30Z0M9
M1

I've tried doing a little bit of editing to the post, but no good results yet. I went back to my backup version of the post for now.....

(MCAM X)

[ObrienDave]

Post a copy of your .pst file.
I can fix it for you.

[gearsoup]

let's see if this works.....

I don't mind having you do it. But, I would like to know what you did, just so I know...

Also, is it possible to output an "N" only at the beginning of eah tool? And increment by 10's?

N10 G0GG80G90G94G98

N20 ETC ETC ETC

[ObrienDave]

Yes it is.
You have to go through the pst file line by line and remove the "n," fron the beginning, everywhere you do NOT want the line numbering.
The line number increment is set in the configuration file not the post.
Since your using 10, the increment is set in the control definition file.
And you would remove "n$,"

I'll fix the rest of your post shortly.