Looking for a MC X post for a Centroid M-15 and ProtoTRAK VL...

[squale]

Hi, I was just wondering if anybody could help me out with this.

I have Mastercam X and was looking for the following post processors to work with my machines.

1.) Bridgeport 3-axis vertical mill. Using a Centroid M-15 cnc controller.

2.) SWI Trak Lathe. Using a ProtoTRAK VL cnc controller.

Thank you, any help is very much appreciated!

[Steve Arteman]

I have all those and you do too if you look in the post folder. I do have some good proto track lathe posts that I had to edit to get them to run. the one out of the box is a little strange at least on the two machine I tested on.

[Mike Mattera]

Can you send me some code from the M15. I have a bullett proof M4 Centroid. Much better than the one that comes with Mastercam.

mike@mmattera.com

Mike Mattera