Need to edit Haas post

[cadcam]

Shotout, how about this layout for you.
%
O0001 (T REV: )
(T )
(MACHINE TOOL : HAAS VMC )
(DATE -06-12-07 )
(TIME -19:08 )
(*)
(MATERIAL: )
(STOCK SIZE: X = 0. Y = 0. Z = 0. )
(HOME POSTION COORIDNATES ARE THE FOLLOWING)
(X= )
(Y= )
(Z= TOP OF PART)
(*)
( TOOL - 1 DIA. - .3125 5/16 FLAT ENDMILL )
( TOOL - 2 DIA. - .031 #68 DRILL )
(*)
(USING FIXTURE OFFSETS: G54 )
(*)
N100 G20
N102 G0 G17 G40 G49 G80 G90
N104 T1 M6 ( TOOL - 1 DIA. - .3125 5/16 FLAT ENDMILL )
N106 G0 G90 G54 X.2281 Y-1.9064 S4889 M3
N108 G43 H1 Z.25
N110 Z.1
N112 G1 Z0. F6.4
N114 Y-1.5939 F24.2
N116 G3 X-.0844 Y-1.2814 I-.3125
N118 G1 X-2.3878
N120 G2 X-2.5441 Y-1.1252 J.1562
N122 G1 Y1.419
N124 G2 X-2.3878 Y1.5752 I.1563
N126 G1 X2.2191
N128 G2 X2.3753 Y1.419 J-.1562
N130 G1 Y-1.1252
N132 G2 X2.2191 Y-1.2814 I-.1562
N134 G1 X-.0844
N136 G3 X-.3969 Y-1.5939 J-.3125
N138 G1 Y-1.9064
N140 Z.1 F6.4
N142 G0 Z.25 M9
N144 T2 M6 ( TOOL - 2 DIA. - .031 #68 DRILL )
N146 G0 G90 G54 X-1.844 Y1.0314 S5000 M3
N148 G43 H2 Z.1
N150 G99 G81 Z0. R.1 F1.4
N152 X-1.869 Y-.5251
N154 X1.4252 Y-.6438
N156 X1.5815 Y.7064
N158 G80 M9
N160 G0 Z2.5 X0. Y2.0
N162 G91 G28 Z0.
N164 G28 Y0.
N166 M30
%

if you use the stock setup it will put that info in the stcok location. and it will tell you all the offsets and what they are.I add the little info you asked for at the end so it posts out.
Would this be what you want?

[Shotout]

cadcam

I appreciate it but that post was from Oct 06 and was revived. I had edited the post but since we have upgraded and have machine specific posts we purchased from our reseller. Thank you though for taking the time to answer.