Post for a vickers acromatic control

[tobyaxis]

Being New to MC I see that some Post Processors need a little tweeking, but for the most part they work as is. Have to tried asking on the eMastercam Forum?
Lots of smart guys there that can help.

[Palafox]

Originally Posted by Julian M I updated this to MCX with a chook, and it worked fine. I have made a couple of mods of my own which also seem to be ok. Thanks again. Julian

Can you tell me how do you installed the post? I tried to do it, but I get an error.

[Julian M]

Originally Posted by Palafox Can you tell me how do you installed the post? I tried to do it, but I get an error.

Palafox, hold alt and press C, then open updatepost.dll, complete this window remember to select updating from MC8. This should hopefuly work.

Julian

[Palafox]

I get the following error:

"The selected post has not been updated for this version of Mastercam. Use the UpdatePost.dll utility to update the post processor file".

I found the updatepost.dll file but I dont know how to use it.

[acromastic]

Does anyone have a post Gibbscam, or Camworks for a acromatic 2100. I need a good post for either program.
Thanks

[tobyaxis]

Originally Posted by acromastic Does anyone have a post Gibbscam, or Camworks for a acromatic 2100. I need a good post for either program. Thanks

You could by the New BobCAD/CAM V2007. The Post processors are easy to Modify, plus Post Processors are FREE!!!!!!