Mastercam X updatepost help

[Ymryl]

If you are running a Thermwood post that you bought from them you will have to contact them to update it. They have logic in the binned portion (.psb) that checks the version of the software and bails out if it does not match the version that the post was written for.

[JWWalthall]

I would like to thank everyone that responded to my problem. I did get the post to output code after I removed the old update and re-ran the C-hook. I am now comparing the code with code that was made using V9 that I know is good. Thanks Again!

Jim W