Post for EMC (Enhanced Machine Controller)

[curriedgoat]

Is there a compatible post processor file in Mastercam 9.1sp2 for EMC?

Thanks,
Bronson

[psychomill]

I know nothing about the code requirements for an EMC. Have you tried just posting stuff through any of the generic posts to see if any are close? From there you can modify the posts some to output all that you need. Your dealer may even be able to track one down and supply one.

[curriedgoat]

I have tried several post files and I think most are pretty close, since I am using a simple miniature mill.

I was curious to know if there is a "best" one to use and save some time.

Thanks,
Bronson