Need to output G84 with IPR (mazak - eia) - CNCzone.com-The Largest Machinist Community on the net!

11-17-2011, 10:59 AM

paradiddle paradiddle is offline

Join Date: Jun 2008

Location: US

Posts: 12

Need to output G84 with IPR (mazak - eia)

permalink

I am using generic Haas 4x to output code with X5 and it is almost spot on.

I do need to output G84 feed rate as IPR and I can't find a toggle in tool setup or maybe variable calculation in the post. I want to finish editing this post and MMD to make it Mazak only with .eia eventually.

I also need to remove the 4th axis "A" stuff also. I did remove a "C" in the post in header area but don't know how to remove after that.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Output b-axis degree on a Mazak Horizontal HCN-5000	chestervomkorte	Mazak, Mitsubishi, Mazatrol	0	10-30-2011 05:48 AM
Mazak MYSTERY. HOW do you clear this ANNOYING Mazak alarm??!!! NOBODY KNOWS!!	Mill&Lathe	Mazak, Mitsubishi, Mazatrol	15	10-06-2011 08:44 PM
Problem- How to output time code in Mazak E650??	Terence Toh	Mazak, Mitsubishi, Mazatrol	1	07-06-2010 08:34 PM
Mazak M2 parameters - output to pc	nlh	Mazak, Mitsubishi, Mazatrol	0	06-01-2009 11:46 AM
Mazak QT-200,Mazak VTC-160A,Mazak FJV-250 all pcb problem	sting_dot	Mazak, Mitsubishi, Mazatrol	0	05-21-2007 08:20 PM

All times are GMT -5. The time now is 05:32 AM.