| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-06-2011, 10:32 AM
| |||
| |||
Hi everyone! I have a problem when I filter a program, because recently at the end of the program doesn`t have a line that indicate the machine go home, only go to z0. and x and y remain in the last position, and before when I filtered the program, the machine went home correctly  |
|
#2
09-06-2011, 06:17 PM
| ||||
| ||||
| You probably should contact you dealer for Mastercam and ask them to look at your post. There might be something that is blocking the line of code. They probably could figure that out pretty quick. Sorry I could not be any help on this.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| Tags |
| filter, helpo to filter, mill 7.2b, post processor, problem with filter |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- arc filter | tds11223 | Mastercam | 1 | 09-01-2011 01:22 PM |
| Need Help!- *NEWBIE* Power Line filter (Transformer vs. Filter) | cjchands | General Electronics Discussion | 5 | 09-25-2009 08:36 PM |
| Need Help!- Super Mini Mill 2 Buzzing from Air filter/regulator | Gabe Newell | Haas Mills | 4 | 09-01-2009 03:43 PM |
| Need Help!- Mastercam Mill v9.1 | randycasey | Mastercam | 3 | 04-30-2009 02:05 PM |
| Mastercam Mill v9 | mtandout | Want To Buy...Need help! | 5 | 01-04-2008 12:47 PM |
| | |
Linear Mode
