heidenhain post for tos facing head

[ben82]

Hi guys.

i searched and searched and nothing come up for this one. I would really appreciate if someone here could give me a hint how to get post processor for mastercam x for heidenhain control for facing head ld650, or any turning post processor for heidenhain control.
Thanks in advance..

Ben

[jeffliu2]

Originally Posted by ben82 Hi guys. i searched and searched and nothing come up for this one. I would really appreciate if someone here could give me a hint how to get post processor for mastercam x for heidenhain control for facing head ld650, or any turning post processor for heidenhain control. Thanks in advance.. Ben

Try to find from JeffCNC

[ben82]

NO LUCK

[postguy]

Originally Posted by ben82 NO LUCK

In MasterCAM POST Center

[ak762]

I went and did not find anything, May be you clarify how to find right post there

[postguy]

Originally Posted by ak762 I went and did not find anything, May be you clarify how to find right post there

You need sign in first, and then go "download center" - "mastercam download center", you will find "MasterCAM POST Center" on the bottom.

If you have any problem, you can post your question on JeffCNC MasterCAM Forum , I will help you there.

[ak762]

Originally Posted by ben82 Hi guys. how to get post processor for mastercam x for heidenhain control for facing head ld650, or any turning post processor for heidenhain control.

OK,
I found but I doubt it can help to topic starter. It is mill post ver9

[ben82]

yep i found it too but its a post for milling and i need a turning post.ANYONE??!!