Small post change

[Mark and Poco]

Help looking for a small change in a post for Mastercam X3 Lathe. anyone know what in the post I need to change to make it post with following and trailing zero's, and no decimal. Example 1.0987 to 10987 or .035 to 350 etc. Also I need to remove the g54 in the post. I am running thru the generic fanuc post. everything else is ok. Just need those addressed. I have been stuck doing it by hand.
any help would be greatly appericiated.

[SSConsulting]

If you send me the post, I can do that for you. It's a pretty straight forward thing to do.