masterCam V 9.1 to Brother post - CNCzone.com-The Largest Machinist Community on the net!

toolmaker2001 · #1 10-05-2010, 03:24 PM

HI,

We have just purchased a Brother TC-S2A mill that we would like to use our MasterCam V9.1 on. We cannot seem to find a post anywhere. Has anybody used MasterCam on a brother? All of our older brothers have conversational programming so it wasn't an issue. The new one can go either way and we would like to try. Any help pointing me in the right direction would be appreciated.

Superman · #2 10-05-2010, 08:20 PM

Put up some sample ISO code, so we could also suggest a post that may be very similar. And that could be modified to suit your machine

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Brother -S2A Post	toolmaker2001	Mastercam	4	02-05-2011 10:43 AM
Brother TC-228 Post (any software)	h_2_o	Post Processor Files	16	08-23-2009 01:46 PM
Mastercam w/ Brother TC-2SA	lwilliams70	Mastercam	0	11-26-2007 03:38 PM
Post for a Brother HS 70A	ewest	Esprit	3	06-13-2007 09:35 AM
BROTHER HS-70A Post	asylumua	General CNC (Mill and Lathe) Control Software (NC)	0	04-12-2006 05:54 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)