O OH!! . Looks like the guys on the forum is stuck in helping with my problem.
Not to worry. I some how expected this to happen. In my search for awnsers I got hold of the Post procesor Ref. Guide from Mastercam. It took a while to figure out but I managed to fix som of my problems.Here they are!!!
#1. Tool change almost fixed. Everything outputs fine exept for the offset number value( H ). It stays on 0.It does not change from tool to tool. Still working on this one!!!
#2. G32 comand fixed
#3. G76 still in the pipe line. Any help will be apreciated!!!!!!