Results 1 to 1 of 1

Thread: water jet in mastercam

  1. 03-20-2010, 12:04 PM #1
    inkydo69
    inkydo69 is offline
    Registered
    Join Date
    Oct 2008
    Location
    USA
    Posts
    45
    Downloads
    0
    Uploads
    0

    water jet in mastercam

    I hope everyone has been doing well I haven’t had much time to post much here just been busy, I hope everyone is doing well.
    Question for the community and thanks for any input on the subject.

    Is anyone out there using Mastercam to run a Hydrajet - Waterjet Cutting System Accura 6'x10' Cutting Area or something very close to this?

    Thanks,
    Eric

    could somone move this to the main page lol if not np!
    Last edited by inkydo69; 03-20-2010 at 06:17 PM.

« postprocesor for Heidenheim TNC 426 | Servo cnc mill to Mcam 9.1 post? »

Similar Threads

  1. Need Help!- used water jet
    By Jim Huston in forum General Waterjet
    Replies: 2
    Last Post: 01-16-2009, 09:33 AM
  2. Need Help!- Does anybody know what to mix in the water, on a water table?
    By suzukirmz in forum General Waterjet
    Replies: 8
    Last Post: 06-22-2008, 12:56 AM
  3. Who has a water jet?
    By fastolds in forum Employment Opportunity
    Replies: 3
    Last Post: 10-22-2007, 10:13 PM
  4. Water transfer techniques for water table?
    By Knut in forum General Waterjet
    Replies: 3
    Last Post: 02-02-2007, 10:52 AM
  5. looking for water jet in LA
    By the4thseal in forum Employment Opportunity
    Replies: 7
    Last Post: 11-14-2005, 07:58 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.