Need Help!- Bosch CC120 M

[mael]

Hello,

would like to know if someone have experience whith this type of controller 5 BOSCH CC 100 / 120 / 220

i'am trying to run a wood router RYE MG 24020 whith a single spindel and no tool change, whith ARTCAM soft,


To moove the axis X; Y; Z; i must give a G code negativ, ( X-1200 Y-250 Z-140 )

My problem is : how to write that negativ value in the post-processor file.
at the moment only the Z axis is negativ and i did not understand why in the structure of the post processor file.

Thank you very much.