powermill post editing

[masterblaster]

I am a new member and I am going nuts trying to swap a ductpost file to a dmp file .I have gone to the right directory and do everything right as far as the commands, but I can't get a file swapped. I go to the duc~ost1400,sys,exec,directory and do the -w > .dmp swap but all ways get a paf error????? I've tried it in the config folder also but no luck???I'm ready to shoot my PC???help somebody. I need to edit the post for my MIKRON with a heidenhan controller. -------All set now, don't really know why I was having such a bad time of it. I don't think i was actually switching into the right dir first.

[ikram]

hello all.
i m ikram
here a problem about power mill 10 sp5 that (unable to run power mill due to the following PAF error)PAF=4 line =8191.
kindly any body help me to about the problem .my e mail address (haider_watchcnc@yahoo.com)

regards!

ikram.