Need Help!- post proc modification

[olav62]

Hi everyone,

I'm not a post proc expert and i'd like to know if somebody could modifie one for me.

What the original post proc do is :

When i run a G-code file in MACH3

"Z" is up, spindle starts, "X" and "Y" move to the starting position, "Z" goes down

At the end of the file, "Z" retracts "X" and "Y" move to home and spindle stops.


What i'd like the post proc do :


"Z" is up, "X" and "Y" move to starting position, spindle starts, "Z" goes down.

At the end of the file, "Z" retracts, spindle stops, "X" and "Y" move to home

(I've copied and paste the post proc file in a word document)

Tks in advance for your help

Regards

OLIVIER