Post Processor Help Please

[StefanW]

Hi Peeps. i was wondering if someone could give me some advice, i have a copy of featurecam 2007 and was wondering what post processor i have to use for xyz smx milling machine fitted with a prototrack controller?

any help or advice would be very much appriciated

Kind Regards

Stefan

[StefanW]

Still none the wiser surely some kind soul out there could help me

Stefan

[harley4ever]

I dont know much about it but it may be beneficial to post in the Featurecam section. More people that use Featurecam probably check that than the "post processors" section.