I've got trouble with 5-axis mill. Especially with its rotary table. How to make a post (mb to use custom command) that post processor would make something like this:
It's needed that fourth axis A is 25. for example.
But in G-code it should be posted like A-25. B180.
There is no need to du such a transformation with negavive angles
All the positive angles of fourth axis must me mirrored to the negative side with rotation of fifth axis to 180 degrees
Could anyone help me to solve this problem?
Last edited by i0wa; 10-04-2009 at 11:39 AM.