Post for edgecam - heidenhain430 - CNCzone.com-The Largest Machinist Community on the net!

MXL · #1 05-12-2009, 02:35 PM

Need a post for this combo.
Can anyone help me?

Mail: edwins-email@gmx.net

Rob 1264 · #2 06-09-2009, 05:24 AM

Hi There,

I will send you a post ( to your Email address) that might get you started.

Hope it helps you if you have not already found one.

Regards

Rob

MXL · #3 06-09-2009, 06:18 AM

That would be great!

MXL · #4 06-25-2009, 02:17 PM

Did you sent me anything?
I didn't get your mail....

Rob 1264 · #5 06-26-2009, 04:28 AM

Yes I sent you an Email, but it bounced back! Did you write your email correctly?

MXL · #6 06-26-2009, 04:44 AM

Yes, I tested it and it works fine.

Try h-nieuwenhuis@chello.nl , maybe that one works for you.
Thank you

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Deckel Evo 50 Post for Edgecam	jonksey	Post Processor Files	1	01-13-2011 02:54 PM
Edgecam Post for Mazak VQC M2	zabba	Post Processor Files	0	02-21-2008 03:30 AM
EdgeCam Post for Daewoo	machineDynamics	Post Processor Files	1	01-26-2007 09:50 AM
EdgeCam Post for Daewoo	machineDynamics	Daewoo/Doosan	0	01-05-2007 10:22 AM
edgecam post for deckel	smoregrava	EdgeCam	2	11-22-2006 10:54 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)