| | |
Mastercam post for Heindenhain
Hi,
Does anyone have Mastercam V9 and X2 post for Heindenhain iTNC 530 control conversational format. Ideally I need 5 axis post but for now 3 axis post would do just fine, please e-mail to g223426@hotmail.com
I would be very grateful
Thank you
Never seen one for conversational side and doubt that you will see one. That's a huge undertaking with all of the verbage...Why not just pick up an Offline program software from Heidenhain?
It's just a part..... cutter still goes round and round....
Posting Permissions
| | |
LinkBack URL
About LinkBacks
