Need help editing Mastercam 8.1 to Fagor 8055 i

[car_guy_549]

Hey guys,
I need a little help with a couple of lines on a post for Mastercam 8.1 to Fagor 8055 i . For some reason the control wants the spindle speed and M03 on a line by themselves and also I need the D offset word to come directly after the T word on the same line. I have been able to change the Fanuc generic post until the machine only has these 2 problems but I'd like to fix this and get the shop people out of my hair.
Thanks, Steve

[ObrienDave]

Post a copy of your .pst and .txt file, a copy of the code your getting, and how you would like it to be fixed, here.
I can try to fix it for you, no charge.
I will document, in the post file, where I made the changes.

[cam1]

Hi: We have a VMC with Fagor 8055M control, here's a post that works very well.

regards

[car_guy_549]

Thanks guys. I have it fixed so the machine will run without any errors so far. I don't think the shop has tried everything out yet but so far so good. Thanks for the post. I'll look it over when I get time, there may still be something in there I can use.
Thanks again for your replies.

[ashlie]

hie,
im using mastercam 8,wanna do program for fagor8055,i got one post processor but it shows error "variable not defined"

does anyone having post processor for tht??help....