We're currently starting to use NX5 for our programming software. I found the generic posts, but where can I find specific custom Mori posts that will output set-up sheet info, cycle times, etc. After completing the 2 axis posts, we need to find the Mori mill-turns posts.
Thanks,
Although there are shopdocs available in the default install most users program their own. You can let the postprocessor create a set up sheet. It requires a bit of tcl programming to get it right.
Jelmer
www.rouwe-analysis.info
Thanks for the reply. I've been playing with the post & have it pretty close.
However, being new to NX and editting the .tcl files, it's taking more time than I have.
Do you use a canned cycle for threading or is it long hand? I will be using long hand, but I am not to sure how to output it.
If I can I use canned cycles, less work but sometimes the requirements are different. What do you want to output?
I prefer not to use canned cycles, even though they are more convenient.
The reason not to is have more control on the shop not editting the programs.
Thanks,
Posting Permissions
LinkBack URL
About LinkBacks
