Need Help for Mastercam/Fadal

[cncbobman]

Hello,

Is there anyone who can help me on how to change the Master Cam X post processor so it can create a Part program like below?
I just started a new job and I'm new to Fadal controls.

I' not sure if the program below is a common way of programming in Fadal, but I have seen more logical ways.
On the top there are the subroutines and the then follows the main program, but my current post won't spit it out that way. If I change my
Control Definition to "Sub programs before main Program" It will give me an empty part program.
Any suggestions our help are greatly appreciated!
Thanks, Bob



%
N1O1 (MD01012 INSERT #3)

N2 L100

N3 X-0.375Y-0.3

N4 Z-0.52

N5 G41 X0

N6 G1 Y0.38

N7 G0 Z0.2

N8 G40

N9 M17

N10 L200

N11 X 1.625Y0.38

N12 Z-0.52

N13 G1 G41 X1.35

N14 Y-0.35

N15 G0 Z0.2

N16 G40

N17 M17

N18 L300

N19 X1.4 Y-0.35

N20 Z-0.225

N21 G1 G41 Y0.06

N22 X-0.5

N23 Z-0.125

N24 G40

N25 Y0.125

N26 X1.36

N27 G0 Z0.2

N28 M17

N29 L400

N30 L101

N31 L201

N32 L301

N33 M17

N34 M30

N35 G0 G17 G40 G80 G90 G94 G98

N36 T1 M6 (1/2 ROUGH)

N37 S1200 M3 M8

N38 H1 Z0.5 D1 F7.5

N39 E1

N40 L401

N41 E2

N42 L401

N43 E3

N44L 401

N45 E4

N46 L401

N47 G0 G80 G90 Z2. M5 M9

N48 T2 M6 (1/2 HIGH HELIX)

N49 S3500 M3 M8

N50 H2 Z0.5 D2 F35.

N51 E1

N52 L402

N53 E2

N54 L402

N55 E3

N56 L402

N57 E4

N58 L402

N59 G0 G80 G90 Z2. M5 M9

N60 G53 Z0

N61 M6

N62 X0 Y0 Z0 E0 H0

N63 M30

%