Microkinetics Postprocessors

[got_woody]

Hi all,
I have just bout a use Microkinetics 1236 lathe and was wondering if anyone has a post processor for gibbs 2006 and teksoft 2006 that would work for this lathe. It uses turnmaster pro 2006. also dose anyone know how the limit switches diagram for x and z are to be wired?.
thanks for any help,
my e-mail is got_woody@yahoo.com
thanks again
got_woody

[got_woody]

programing is so diff it dose not use R it uses I K
I have alot of proessor if there is another machine that uses the type of code I might have it but I dont know what machine uses this code.
thanks got_woody

[got_woody]

could someone please point me in the right direction to what is the best way to propram turnmaster pro. I would like to use gibbs but if there is another way I would like to look in to it.
thanks
got_woody

[got_woody]

I have a seat for gibbscam at work that I would like to use to make my programs with but I dont have a post for turnmaster pro. can anyone help please. I have alot of money in this lathe and I wont to use it to pay for its self but with out a post prosser it will take forever to program.
thanks
got_woody

[got_woody]

is there something I am doing wrong I have had no replys.
thanks
got_woody

[got_woody]

Hi dose anyone know why or what I can do to get my spinde encoder and feed over ride. to work? I have a Optistep Plus Controller and they both plug in to it.
Thanks Barney
there are not many post on this site about the 1236 Microkinetics lathes.

[rgpsales]

Hey Woody,

Why not simply contact your GibbsCAM reseller and purchase a post? Seems like the money being lost each day this machine is non-operational would more than justify the cost of a post processor.