Needed Mastercam X Post for TNC 145 - CNCzone.com-The Largest Machinist Community on the net!

Joe_Leen · #1 06-03-2007, 07:13 AM

Hi all,

I'm looking for a Mastercam X post processor for a Heidenhain TNC 145 controller. Thanks for the help : )

Joe

Simtech · #2 07-08-2007, 08:45 AM

What type of machine?
In Klartext or G-code format?
How many axis?

Regards

Joe_Leen · #3 07-08-2007, 06:14 PM

Hi there,

Its a 3-axis Bridgeport Interact 2 Series II milling machine.
It's G-code I want to run.

Thanks,

Joe

Simtech · #4 07-09-2007, 10:45 AM

Provide a MCX file with G-code file as needed and I can evaluate the work needed.

Send via e-mail.

markmann · #5 06-09-2008, 05:09 PM

anyone have a tnc 151 post for mastercam if so could you email to me thanks, mark pirate9705p@aol.com

PROCEL · #6 10-31-2008, 02:54 PM

HEY JOE,
Did you ever get that tnc 145 mcx post? If so I sure could use a copy of it.
Thanks,
JAY

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mastercam to Galil Post processor needed	bbutcher85710	Post Processors for MC	5	04-16-2010 08:27 PM
Mastercam 9 post needed for EZVISION MILL	SHREDNU	Post Processor Files	1	06-09-2007 01:34 AM
MasterCam X Fanuc 10M Post needed	jonesr	Post Processor Files	0	04-10-2007 09:12 PM
mastercam 3D designer needed for project	camarogod98	Mastercam	7	11-17-2006 11:11 AM
mastercam info needed	publitime	Mastercam	13	08-01-2004 06:55 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)