post processor for itnc 530 - CNCzone.com-The Largest Machinist Community on the net!

Priyank Avhad · #1 04-17-2007, 03:30 PM

I need the post processor for a DMG 635V with Heidenhain itnc 530 controller............any help in that regard will be highly appreciated...
Regards

jelmerra · #2 04-18-2007, 01:11 PM

I suppose you need a post processor that converts apt to hh conversational. Not sure if I can help I write post processors for nx but I can give it a try if you send me an apt file.

Priyank Avhad · #3 04-18-2007, 02:49 PM

i am quite new to this field...am looking for a post processor for a cam software like mastercam that will convert the data into heidenhain readable format for the machine..in short lookin to establish a link between computer and machine

jelmerra · #4 04-18-2007, 03:29 PM

I suppose you already found this one: http://www.mcadcentral.com/proe/foru...984&PN=2&TPN=2

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
post-processor	JDW	General CNC (Mill and Lathe) Control Software (NC)	4	04-02-2008 03:23 PM
ITNC 530 smat.nc HELP	pompey steve	Deckel, Maho, Aciera, Abene Mills	2	03-09-2008 03:07 AM
Heidenhain iTNC 530	Thanya	General CNC (Mill and Lathe) Control Software (NC)	2	03-12-2007 04:33 PM
post processor help	jrrhotrod	Post Processor Files	8	01-14-2005 03:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)