changing dwell in peck cycle - CNCzone.com-The Largest Machinist Community on the net!

02-03-2007, 01:31 AM

cncmedcom

*Registered User*

Join Date: Feb 2007

Location: australia

Posts: 13

changing dwell in peck cycle

permalink

hi everyone,
i was wondering if anyone can help me with mastercam peck cycles. I wish to change the post so the dwell occurs after the drill rapids out instead of at the bottom of the hole. i have a fanuc post and have tried changing the post but i just cant quite get it right. i am not using canned cycles (dont have that luxury) and i often write 20mm deep peck cycles at .1mm per peck. i am using the generic fanuc post. would greatly appreciate some help.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
peck tapping cycle	jdsmith0524	General Metal Working Machines	9	12-16-2006 10:36 PM
Dwell question	cosmynnec	Mach Software (ArtSoft software)	2	07-17-2006 10:10 AM
Q: How to dwell	Teps71	Milltronics	18	04-07-2006 03:32 PM
fanuc -om peck cycle	PETE1968	Fanuc	4	04-05-2006 09:57 PM
G83 peck Drill cycle	Vaughan	G-Code Programing	24	03-19-2004 11:11 AM

All times are GMT -5. The time now is 10:48 AM.