Help needed with Mori Seiki MV Junior post

[Baxter]

I need a post for Mori Seiki MV Junior milling machine, Fanuc 10M,(im running Mastercam 8.1), that seperates the tool select command from the tool change command putting it onto a seperate line.

i.e.

The standard post produces

N100 T1M6

I need the post to produce

N100 T1
N110 M6


and will also move the Y axis to at least the 100mm from the reference point as required by the Mori for the tool change position, but still return to the XY reference point at the end of a job.

[Steve Arteman]

Baxter I sent you an email

[Baxter]

Thanks for your reply Steve,
I'm sorry for the delay.I am a very infrequent netter and I have been tolerating my present post processor for several years, so no rush. I will now be making sure that I have described all of the existing posts faults and then I will probably be in touch.
Kind regards and happy Christmas. Baxter.