-
Registered
Bridgeport EZ-Trac post processor
Hi, I am new to this. I have been a cnc machinist for 12 years. I know procam (Teksoft) very well. I just got a Bridgeport EZ-Trac and need a post processor for it I cant find one anywere. Dose anyone have one Please!! my email is got_woody@yahoo.com. my biggest problem is trying to do arcs there is no were to put the tool Dia, and if you add half the tool size or subtract it dose not come out right? if any one can help that would be great thanks got_woody
Last edited by got_woody; 08-31-2006 at 07:50 PM.
-
-
Registered
thanks that worked great!! if anyone has the ez path post I could use that too.
thanks again
-
Registered
Did you try the teksoft dowload page?
I know there's one for Camworks, there should be one for Procam too.
enat
Posting Permissions