Mc 9.0 post for Mat 510

[bearjk]

I am editing a post for a Matsura 510. I am using the generic post that came
with M.c. Ihave been able to do some things but am stuck on a few.
The second line right after my program # has a
G54 X...Y...Z.1. The values correspond with the location of the first
tool. I have edited my header all right but I can't find this one.
Also an "A0" shows up at the end of the first position line for a non
drilling sequence. I don't see that either. I have the post processor
reference on pdf and that has helped but I've only had it a short time.
I know I can contact my reseller But I usually have better luck getting tips
from real users who work with this stuff in the real world. I'm sure there will
be more question but this will do for now.

Thanks for your input
Bearjk

[Mike Mattera]

The G54 is output in the pwcs section of the post.

As for the "A" axis output... Go towatd the end of the post ans look for the numberes questions. I think you want to change question 164. It will say something like this...

164 Use rotary output : yes

Change it to a no.

Mike Mattera