mastercam post for centroid ?

[cadchris]

I recenley upgraded from mastercam v6 to v9 and now the post won't put numbers on my line's like N100 and also it calls for a toolchange everytime it picks up now. what can i change in the post to fix this?

Thanks

[lakeside]

scriping is something if you don't understand is best left to mastercam if you give them a call I sure they will walk you though it

[Mike Mattera]

V9 comes with a Centroid post MPM4.

Try that.

Mike Mattera

[cadchris]

can i find m4p4.pst at? I don't seem to have it!

Thanks

[Mike Mattera]

Did you install all the posts from your CD? If not re-insert the CD and install the posts. It will put the posts in the C:\Mcam9\Mill\Posts folder.

Mike Mattera

[dbb135]

The correct post is MPCENM4. This is what I use for my Centroid M400 control. I can email it to you if you would like.

Dan

[cadchris]

please do at cdevido@aol.com

thank you

[JaneGao]

you can try it in control ,in Control there is a NC output,you can change them

[cadchris]

where is control at? centroid or mastercam?