Kitamura - Yasnac-i80M post

[grantmi1]

Could some show me the first lines and last lines of their NC code so I can build it into my post. I am new to the control and having a hard time figuring it out. I need to see what G code callouts are needed. If you want send me the hole damn NC file.

[psychomill]

For what software????

[Rekd]

Originally Posted by psychomill For what software????

Any software, he just needs to know what the code looks like.

I have an old post for a kit around, I'll see if I can dig it up. It's not much different than HAAS.

[psychomill]

Thanks Rekd,.....

I'm a little more refreshed this morning,.... I actually read his question this time.....

[grantmi1]

Thanks guys. Yes I thought being software specific would limit my answers to much. The software I am using is EdgeCam though.

[grantmi1]

I figured it out, now that I know what the machine needs I wrote my own post. Thanks Rekd

[Rekd]

Originally Posted by grantmi1 I figured it out, now that I know what the machine needs I wrote my own post. Thanks Rekd

No problem, sorry for the delay. Like I said, it's generic Yasnac, so verify before you run it.

[blkhrt13]

i just started running one at work about 3 months ago.I can tell you alot about what it will and wont do.let me know what questions i can help with.Dont know about posts for camware Im old school.I program by head and hand.I get by better than they did before me.

[trafficbikes]

I have the same controller and need to write a post for my Kitamura Mycenter Zero. Can someone share theirs?