Fanuc 18i post - CNCzone.com-The Largest Machinist Community on the net!

col · #1 07-25-2005, 03:56 PM

Has anyone got a post for Fanuc 18i that works with a Mitubishi M-V5Cn please.

psychomill · #2 07-25-2005, 06:54 PM

For what software?

col · #3 07-27-2005, 03:58 PM

Psyhomill,
Thanks for your reply , the software I have is Mastercam mill and the Machine Iam using is mitsubishi M-V5Cn with fanuc series 18i-m control.
Hope this help.
Col

psychomill · #4 07-27-2005, 05:48 PM

Have you tried using the MPFAN.pst post that comes with your MasterCam? Or do you just need some editing to the post to get what you need?

col · #5 07-28-2005, 02:40 PM

Psychomill,
Thank's again for your reply , yes I have treid MPFAN on my MasterCam and the editing to the post is my other alternative, which I am about have a look at with a bit of help from a work mate , I must confess to not being an expert , I was just looking for a short cut.
Thank's for your help.
Col.

psychomill · #6 07-28-2005, 03:32 PM

Posts are totally customizable so its probably the way to go. I'm sure someone out there has a "good post" that works for a particular machine, however in many cases, you want a few more things added or some things removed.

If you do need a little help with adding/removing some stuff, there are several of us here that can help you with that. Good luck.

Dablyx · #7 07-19-2006, 08:00 AM

Hy guys
I need a postprocessor for Fanuc Series 18i on Miyano BNE-515 and I am programing in ProE.
Anyone have an idea where can i get it?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)